Table of Contents
Advertisement
Introduction
Overview
The Power Modules belong to the modular family of SINAMICS G120 converters. A modular
converter comprises Control Unit and Power Module.
Depending on the power rating in frame sizes FSD ... FSF, the following Power Module
versions are supplied:
• 3 AC 400 V
• 3 AC 690 V
Control Units for the Power Modules
You can operate the Power Modules with a Control Unit from one of the following listed
families from firmware version V4.7 SP6 HF1 and higher:
● CU230P-2
● CU230P-2 BT
● CU230P-2 HVAC
● CU240B-2
● CU240E-2
● CU250S-2
Note
Commissioning the converter
You must first commission the converter before you can use it. Commissioning is described
in the operating instructions of the relevant Control Unit.
STO independent of the Control Unit
The Power Modules are suitable for implementing the "Safe Torque Off" (STO) safety
function corresponding to PL e according to EN 13849-1 and SIL 3 to IEC61508.
Note that when using the STO function, the mission time of the converter is restricted. For
more information, see the "Safety Integrated" Function Manual.
Power Module PM240P-2
Hardware Installation Manual, 06/2020, A5E37800827C AD
22 kW ... 132 kW
11 kW ... 132 kW
Manuals for your converter (Page 93)
STO via Power Module terminals (Page 45)
Manuals for your converter (Page 93)
for line voltages from 3 AC 380 V ... 480 V
for line voltages from 3 AC 500 V ... 690 V
2
15
Advertisement
Table of Contents
