Setting The Up Limit - Genie Single Programming, Operation & Maintenance Manual

PROGRAMMING UP TRAVEL LIMIT
Programming UP Limit:
1. Press and hold the UP arrow button.
• Long LED will light BLUE.
2. Release UP arrow button.
• Round LED will flash BLUE.
3. Press and hold the UP arrow button until door is
fully open.
• Use the DOWN arrow button if door opens too
far. Use both UP and DOWN buttons to adjust
open travel as necessary.
Door should fully open so that door seal is even with
door header. Do Not adjust so much that the door will
bend or buckle or stretch door spring cables backward.
4. Press and release the SET/PRGM button
• Both LEDs will flash BLUE then go out.
The UP limit is now programmed.
1-2. Enter Programming Mode
HOLD
UNTIL
LED
Lights
RELEASE
3. Adjust Door Position
4. Lock Programming
Flashing Blue
Steady Blue
Flashing Blue
PRESS
&
RELEASE
7