Chapter 15 Parameter - Mitsubishi Electric MELSEC Q Series User Manual

CHAPTER 15
This chapter describes the parameters required to be set for configuring a C controller module.
(1) Parameter types
The following parameters are provided
• CCPU parameters (Page 289, Section 15.1.1)
These parameters are set when a C controller module is used.
• Network parameters (Page 291, Section 15.1.2)
These parameters are set when a network module is used.
(2) Parameter setting method
Use Setting/monitoring tools for the C Controller module to set parameters.
For operation methods of the setting/monitoring tools for the C Controller module, refer to the following.
Setting/Monitoring Tools for the C Controller Module Version 4 Operating Manual
Remark
Setting/monitoring tools for the C Controller module can set the common function parameters from the equivalent interface
to that of GX Works2.
When referring to the manuals for the programmable controller CPU and modules used for related functions and parameter
setting methods, replace the following parameters as shown below.
• CCPU parameter  PC parameter
• Network parameter CC IE/MELSECNET  Ethernet/CC IE/MELSECNET
(3) Parameter setting procedures
Described below are procedures to create parameters and write into C Controller modules.
1.
Start up the Setting/monitoring tools for the C Controller module.
2.
Create a project.
3.
Set parameters.
4.
Connect the a personal computer to the C Controller module. (Page 125, Section 8.7)
5.
Write the parameters.
[Online]  [Write to CCPU]
6.
Reset the C Controller system. (Page 71, Section 6.3)
The written parameters are applied.
(4) Error detection
If any error occurs in the parameter settings, ERR.LED of the C Controller module is lit.
Use the following functions in Setting/monitoring tools for the C Controller module to check and correct the error
factors.
•
[Diagnostics]  [CCPU diagnostics]
•
[Diagnostics]  [Event history]
Double-clicking an event item in the event history display field shows the "Detailed event information" screen. The
"Detailed event information" shows the Parameter No. (Page 296, Section 15.3).
288
PARAMETER