General Configuration - Mitsubishi MELFA SQ Series Special Specifications Manual

1.6.2 Controller
・ CR1QA-700 series, CR2QA-700 series
Cable
･ 2Q-TUCBL 10M
(TU Cable for robot)
･ 2Q-DISPCBL10M
(DISP Cable for robot )
･ 2Q-EMICBL 10M
(EMI Cable for robot)
･ MR-J3BUS10M-A10M
2A-RZ365(Sink)/
2A-RZ375(Source)
*4) Corresponding to the sink or source to be
used, setting of the drive unit is necessary.
*)Refer to
Table 1-4
USB cable.
*1）
(SSCNET Ⅲ Cable for robot)
for
※ １ ）
The base board, the power supply unit, and
sequencer CPU are required for installation of
the robot CPU unit.
［ ］
*3)
Note) Only for the controller of standard
*3)
※ ２ ）
The previous R28TB can be used if the relay
connector box is used.
And, since the R28TB operation method is the
same as before, refer to the instructions
manual which on hand.

General configuration

1
specification.
*3) The controller of CE Marking
specification
"-S12" specification: the controller
is CR1QA-700 series.
"-S312" specification: the
controller is CR2QA-700 series.
*2）
(MS-Windows2000/XP/Vista)
(MS-Windows2000/XP/Vista)