Specifications; Regulatory Information - Interlogix Simon XT Installation Manual

Walking the Customer through New User Setup on the Web
This section describes how to help your customer set up their website
account, and only applies to customers on an interactive service plan with an
online account. (Skip this step for customers using the module for wireless
signaling only).
Before the customer can configure their website account, the Alarm.com
account for that customer must be created on the Dealer Site, and the LTE
module associated with the account must be installed successfully.
To log in and access their account, the customer can go to www.alarm.com
(or custom dealer website address) to complete the new subscriber setup
procedure.
The customer will need the following:
• The website login and temporary password included on the Alarm.com
Welcome Letter generated when the account was created by the Dealer
• A list of their system sensors and touch screens with corresponding
zone IDs
• At least one phone number and e-mail address where notifications can
be sent
Note: At least one sensor must be learned into the panel to complete the
new subscriber setup. If not all sensors and touch screens were learned in
before powering up the module, an updated sensor list must be requested
by performing an LTE phone test or requesting an updated equipment list
from the Dealer Site.

Specifications

Compatible Simon XT panels with software versions 1.3 and
later, Simon XTi, and Simon XTi-5
Power requirements 6V nominal
Standby current 30mA (10mA in PowerSave Mode)
Peak current 1.7 A
Operating temperature 32 to 120°F (0 to 49°C)
Storage temperature -30 to 140°F (-34 to 60°C)
Max. relative humidity 90% non-condensing
Cellular network Verizon LTE
Dimensions (H x W) 4 1/16 x 1 7/8 in.

Regulatory Information

Listings FCC ID: YL6-143450L, IC: 9111A-143450L
This device contains FCC ID: RI7LE910SV, IC: 5131A-LE910SV
Changes or modifications not expressly approved by Alarm.com can void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Copyright © 2015 Alarm.com | www.alarm.com
Simon XT/XTi/XTi-5 LTE Module
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different form that
which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
(1) This device may not cause interference
(2) This device must accept any interference, including interference that may
cause undesired operation of the device
This equipment complies with the FCC RF radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 20 centimeters between the radiator
and your body.
| v4.2
| Installation Guide
8