Flexpower Power Management System Standard Features - Johnson Controls P2000 Hardware Installation

CKM-CE75-E1M
24-10707-112 Rev. D
I : To prevent premature loss of battery power, maintain batteries at an
MPORTANT
ambient temperature of between 32 and 120°F (0–49°C).
I : Ensure that all wiring is routed and secured to prevent accidental
MPORTANT
open or short circuit conditions.
I : Replace fuses only with fuses of the same type and rating.
MPORTANT
WARNING: Risk of Electric Shock or Fire.
!
Do not expose this equipment to rain or moisture. Doing so may
result in electric shock or fire.
CAUTION: Risk of Damage to the System and Voided
!
Warranty.
Do not use the power supply with a 230 VAC input unless the
input voltage selection jumper (JP1) is cut and removed. Failure
to cut and remove the jumper may cause damage to the system
and will void the warranty.
F P P
LEX OWER OWER
FlexPower's advanced feature set provides greater product reliability, increased
flexibility, shorter installation time, a smaller service inventory, and an
intelligent, economical solution to the problem of reliable system power:
• VSelect®
A single switch for configuring the output between 12 and 24 VDC
eliminates field errors and helps reduce and simplify service inventory by
eliminating the need to stock units in each voltage.
• TruWatt®
The output power capability of the power supply remains constant
regardless of the output voltage setting.For example, a FlexPower 150 watt
supply provides 6 amperes at 24 VDC and 12 amperes at 12 VDC, allowing
you to use the same number of locking devices at either setting.
M S
ANAGEMENT YSTEM
1-2
S F
TANDARD EATURES
Introduction