To Connect Ac Power - Johnson Controls S300 Series Hardware Installation Manual

Hardware Installation
Backplate
 To mount the backplate:
1. Place the backplate inside the enclosure and align the backplate's four
mounting holes with posts in the enclosure.
2. Secure the plate with nuts provided.
 To connect AC power:
1. Put the AC power through the knockout in the left or top panel of the
enclosure.
2. Connect the live wire of the AC power source to the BRN wire through the
terminal strip.
3. Connect the neutral wire of the AC power source to the BLU wire via the
terminal strip.
To AC
power
source
Figure 2-1: Connecting Power Supply to the Terminal Strip
4. Connect the building ground wire to the backplate. Location of the
connection is marked with the ground symbol
N
OTE
European installations require permanently connected equipment to
incorporate a readily accessible disconnect in the fixed wiring.
4
BRN (18 AWG)
L
BRN
N
BLU
BLU (18 AWG)
NC
Terminal strip
This document contains confidential and proprietary information of Johnson Controls
S300-DIN-L
Installed backplate
Grounding shield
termination points
L
N
Power supply
.
24-10239-340 Rev. B
© 2017 Johnson Controls