Johnson Controls P2000 Hardware Installation page 27

CKM-CE75-E1M
24-10707-112 Rev. D
To mount an EP1501 or MR51E:
1. Identify the mounting location in the enclosure.
An EP1501 or MR51E can be mounted in either location A or
B, as shown in
in location B).
2. Select four #6 nuts with integral washers from the enclosure's parts
kit.
3. Orient the EP1501 or MR51E board over the four screws that are
integrated into the back of the enclosure, then push the board down so
that the screws come up through the holes in the board's mounting
plate.
4. Apply one of the four #6 nuts to the corresponding screw until tight.
Repeat for the other three nuts.
5. Once the board is mounted, refer to the manual for the board for
wiring instructions.
Figure 3-8 (as long as an MR50 is not installed
A
CKM-CE75-E1M
Figure 3-8: Mount Locations for EP1501 or MR51E
B
3-9
Installation and Wiring