How To Configure The Redundant Terminal Bus On The Basis Of The Intel Team Mode - Siemens SIMATIC PCS 7 Function Manual

Advantages of fault-tolerant components
4.3 Communication connections
Conditions and rights required
You require the following to be able to install and operate SOFTNET-IE RNA on your PC:
● 2 free Ethernet network adapters
● 2 separate Ethernet network adapters
● Administrator rights for installation
● Exactly one software license for SOFTNET-IE RNA per PC.
Installation and configuration
You can install the "SIMATIC NET SOFTNET-IE RNA" software with the PCS 7 system setup.
Select the "User-defined Installation" installation mode and select the "SOFTNET-IE RNA ..."
program in "Options".
You can find information about the configuration in the
Ethernet Operating Instructions; SOFTNET-IE RNA .
Additional information
● Online help for "SIMATIC NET SOFTNET-IE RNA" software
● You can find additional information on this on the Internet http:\\www.siemens.com/pcs7-
documentation (http:\\www.siemens.com/pcs7-documentation):
– Operating instructions
– Operating instructions
● You can find information on the individual SIMATIC NET products and their configuration
on the Internet (http://www.siemens.com/automation/service&support).
4.3.2.2

How to configure the redundant terminal bus on the basis of the INTEL TEAM mode

Introduction
The NetPro and HW Config programs do not support configuration of the terminal bus. The
PC stations are connected to the redundant terminal bus by means of network adapters
capable of redundancy. The section below describes how you install and configure the drivers
for network adapters of these PC stations.
108
SIMATIC NET; SCALANCE X204RNA, SCALANCE X204RNA
EEC
SIMATIC NET PG/PC; Industrial Ethernet SOFTNET-IE RNA
V8.2
SIMATIC NET; PG/PC - Industrial
Fault-tolerant Process Control Systems (V8.1)
Function Manual, 11/2014, A5E34878832-AA