Gear Case Oil Change; Spark Plug Cleaning And Adjustment - Honda BF2D Series Manual

3) Return the motor vertical. Install a new sealing washer
and oil drain bolt, and tighten the bolt to the specified
torque.
TORQUE: 6.5 N'm (0.65 kgf·m. 4.7Ibf.ft)
4) Refill with the recommended fresh engine oil to the
upper level.
I
Oil capacity
I
0.25 i (0.26 US qt, 0.22 Imp qt)
5) Check the oil level again and add to the upper level of the
inspection window, if necessary.
3. GEAR CASE OIL
Oil Change:
1) Place the outboard motor vertical.
2) Remove the oil level check bolt, oil drain bolt and washer.
and drain the gear case oil into a suitable container.
Check for water in the drained gear case oil.
If there is water in the gear case oil, check the gasket and
water seal for damage and check torque at each tighten-
ing point of the gear case.
3) Using the gear oil bottle (optional part) or commercially
available oil gun, pour fresh gear oil through the oil drain
bolt hole.
Recommended SAE 90 outboard motor gear oil
oil API standard GL-4 or GL-5
Oil capacity
0.05 i (0.05 US qt. 0.04 Imp qt)
4) When the oil flows out of the oil level check hole, install a
new sealing washer and oil check bolt quickly.
5) Then install the oil drain bolt with a new sealing washer.
6) Tighten the oil drain bolt and oil check bolt securely.
TORQUE: 3.5 N'm (0.35 kgf·m. 3.8 Ibf.ft)
4. SPARK PLUG
Cleaning/ Adjustment:
1) Remove the engine cover (P. 4-1) and remove the spark
plug cap.
2) Remove the spark plug using a spark plug wrench.
[1J
OIL CHECK BOLTI
SEALING WASHER
[2J
OIL DRAIN BOLT
I
SEALING WASHER
[1J
GEAR OIL BOTTLE
(Optional part)
[1]
SPARK PLUG
WRENCH
H:ON"DA.
BF2D
_
~~ER
LIMIT
3-3
Page: 23 - Honda BF2D Outboard Motors Shop Manual - http://www.ReadManuals.Com