Steering Handle Disassembly And Reassembly - Honda BF2D Series Manual

b. DISASSEMBLY/REASSEMBLY
• SH, LH, SCH, LCH TYPE
[1] THROTTLE FRICTION BLOCK
REASSEMBLY:
Set in the groove in the
throttle housing securely. Be
sure that the block is not off
in the groove in the housing.
[1 ]-1
THROTTLE
FRICTION
BLOCK
[10]
5 x 22 mm SCREW (2)
4.3 N·m (0.43 kgf·m, 3.1 IbHt)
I
[9]
[3] LOWER THROTTLE HOUSING
REASSEMBLY:
Install the lower throttle
housing by aligning the pin
of the housing with the
hole in the handle pipe.
[3]-1
LOWER THROTTLE
HOUSING
[3]-2
PIN
+.
[6]
MARINE GREASE
[8]
STEERING HANDLE
UPPER THROTTLE HOUSING
• S, L, SC, LC TYPE
[1]
GRIP RUBBER
[2]
STEERING HANDLE
:HON'DA.
BF2C
[5]
FRICTION ADJUSTING BOLT
REASSEMBLY:
Install the U-nut in the
direction shown and screw
it in 2 - 3 turns. Then pull
the adjusting bolt fully.
[5]-1
l
FRICTION
ADJUSTING
/BOLT
[5]~
-. [5]-2
U-NUT Pull
\
\
' \
j
i
j
/
[7] THROTTLE CABLE
REASSEMBLY:
Tighten fully. Hold the throttle
cable parallel to the handle pipe,
and secure with the lock nut.
_~:lIel.
__
&
12-3
Page: 63 - Honda BF2D Outboard Motors Shop Manual - http://www.ReadManuals.Com