SERVICING YOUR OUTBOARD MOTOR
If no oil flows from the oil level hole,
add the recommended oil (p. 81)
following the procedure described in
Gear Case Oil Change.
80
Gear Case Oil Change
Change the gear case oil with the
engine stopped and the outboard
motor in the vertical position.
1. Place a suitable container below the
oil drain hole to catch the used oil,
then remove the oil level screw and
oil drain screw.
2. Allow the used oil to drain
completely, then install an oil pump
adapter in the oil drain hole.
If water or contaminated
(milky-colored) oil flows out the
drain hole when the screw is
removed, have the outboard motor
checked by an authorized Honda
Marine dealer.