Gear Case/Vertical Shaft Disassembly And Reassembly - Honda BF2D Series Manual

15. GEAR CASENERTICAL SHAFT
HOlVDA.
BF2D
I
1. GEAR CASE/VERTICAL SHAFT
1. GEAR CASENERTICAL SHAFT
a.
DISASSEMBLY/REASSEMBLY
After assembly, fill the gear case with the recommended oil.
Recommended oil: API standard GL-4 or GL-5
SAE #90 outboard motor gear oil
Capacity: 0.05
£
(0.05 US qt, 0.04 Imp qt) [2]WATER SEAL
[4]
REPLACEMENT: P. 15-2
VERTICAL SHAFT
[1] GEAR CASE
[20]
[19]
BEVEL PINION
PINION THRUST WASHER
INSTALLATION:
• Install the propeller shaft in the
gear case. Then, pass the verti-
cal shaft through the thrust
washer and bevel pinion and
install the 6 mm E-ring.
• After installation, turn the ver-
tical shaft to check for smooth
propeller shaft rotation.
[19]-1
VERTICAL SHAFT
[19]-2
THRUST WASHER
[19]-3
BEVEL PINION
[19]-4 E-RING
[16]
fit,
[3]
MARINE
GREASE
[7]
BALL BEARING
[6]
GEAR WASHER
SELECTION: P. 15-2
[19]-5
Smm SEALING
r
WASHER (2)
[1S] 01
E-RING [17] L CHECK BOLT (2)
PROPELLER SHAFT
[14] [15] 6 mm WASHER (2)_____
!~
N'm (0.35 kgf·m, 3.8 IbHt) /
6 x 16 mm HEX. BOLT (2) - - - - .
~
/10 N·m (1.0 kgf·m, 7Ibf·ft) /
~~ ~
.
[13] PROPELLER
INSTALLATION:
• Check for cracks
and other damage
before installation.
• Install aligning the
groove in the bush-
ing with the shear
pin.
[12] 3 mm COTTER PIN
[11] WATER SEAL
[S] PROPELLER SHAFT
-1-'
!INSPECTION: P.15-3!
[3]MARINE GREASE
£9] PROPELLER SHAFT
HOLDER GASKET
[10] PROPELLER SHAFT HOLDER
INSTALLATION:
INSTALLATION:
• Use the genuine Honda part or equiv-
alent part.
I
REPLACEMENT: P. 15-2 /
• Note the installation direction.
• Install the propeller shaft holder over
the propeller shaft with care not to
damage the water seal.
• Insert from the side with a smaller
cutout, and bend the other side of the
pin.
~I
[3] MARINE GREASE
INSPECTION: P. 15-3
15-1
Page: 72 . Honda BF2D Outboard Motors Shop Manual· http://www.ReadManuals.Com