Clutch Housing/Exhaust Pipe Removal And Installation - Honda BF2D Series Manual

HONDA
13, CLUTCH HOUSl N G/ENGINE UNDER CASE/EXHAUST PIPE
B F ~ D
1. ENGINE UNDER CASEIEXHAUST PIPE
2. CLUTCH HOUSING
1. ENGINE UNDER CASWEXHAUST PIPE
a.
REMOVAL/INSTALLATION
1) Remove the engine (P. 6-1).
2) Remove the steering handle (P. 12-1).
[21 CLUTCH HOUSING
DISASSEMBLY IREASSEMBLY:
P. 13-3
Do not contaminate the clutch
outer with oil and grease.
ENGINE UNDER CASE
DISASSEMBLYIREASSEMBLY:
P.
13-2
EXHAUST PIPE
8 x 10 mm DOWEL PIN (21
151 MARINE GREASE
INSTALLATION:
Before installation, tap on the
exhaust p i p e l i g h t l y w i t h a
plastic hammer to remove the
carbon deposits f r o m the
inside.
Apply oil or soapy water to the
bottom end where the vertical
shaft bushing is inserted, and
install the exhaust pipe with
care not to allow the bushing
to get out of the position.
131-1 EXHAUST PIPE
[31-3
/
131-2
\
VERTICAL Apply oil
or soapy
SHAFT
water.
BUSHING
13-1
Page: 64 - Honda BF2D Outboard Motors Shop Manual - http://www.ReadManuals.Com