Resizer Interpolation Settings - Sony CCP-8000 Series User Manual

• To shrink, magnify, or move the key, turn on the [LOC XYZ(LOC)].
Hold these buttons down while carrying out the operation of step 5 to
enable fine adjustment (fine mode).
5
Use the trackball and joystick for the operation.
For details of parameters, see step 3 of "Key control block operations for
key shrinking, magnification and movement" (page 257).
Entering parameters
This operation is the same as DME three-dimensional parameter input.
For details, see "Entering Three-Dimensional Parameter Values" in Chapter
11 (Volume 2).
Resetting parameters
This operation is the same as DME three-dimensional parameter resetting.
For details, see "Entering Three-Dimensional Parameter Values" in Chapter
11 (Volume 2).
Clearing resizer effects
To clear two-dimensional transform parameters only and set the
initial state
In the device control block, press the [CLR WORK BUFR] button in the
operation buttons.
To clear all resizer parameters, and set the initial state
In the device control block, press the [CLR WORK BUFR] button in the
operation buttons, twice in rapid succession.
For the initial state, you can select either the factory default settings or user
settings.
For details of how to make this selection, see "Selecting the State After
Powering On (Start Up Menu)" in Chapter 18 (Volume 3).

Resizer Interpolation Settings

For example, to make the interpolation settings for key 1 of the M/E-1 bank,
use the following procedure.
259
Resizer