Replacing The Drain Pump - Bosch WAT28400 Repair Instructions

Repairs
6.17

Replacing the drain pump

The pump, which was supplied with the appliance, is attached with
a screw.
The pump, which is supplied as a spare part, is attached with 4
screws.
The rubber buffers on the mounting points of the screws decouple
the new pump from the housing and thereby muffle the noises
during pumping.
Prerequisite:
• Front panel has been removed.
6.17.1 Removing the drain pump
1. Drain residual water via the emergency drainage hose.
2. Remove screws [ 2] and fastenings from the pump.
3. Press the pump out of the holder.
4. Remove the electrical connection.
2017-05-22 / DIS 113_58300000186503_ara_en_c
5. Loosen drainage hose [ 1] by turning it and pull out of the pump.
6.17.2 Installing the drain pump
► Install drain pump in reverse sequence.
Copyright by BSH Hausgeräte GmbH Page 76 of 85