Replacing Ntc Sensor - Bosch WAT28400 Repair Instructions

Repairs
6.13

Replacing NTC sensor

Fig. 32: Attachment/connections of the NTC sensor
1 Electrical connection
Prerequisite:
• Rear panel has been removed.
6.13.1 Removing NTC sensor
1. Disconnect electrical connection.
2. Loosen hex nut.
3. Pull NTC sensor out of the heater flange.
6.13.2 Installing NTC sensor
► Install NTC sensor in reverse sequence.
2017-05-22 / DIS 113_58300000186503_ara_en_c
2 Hex nut (10 mm)
Copyright by BSH Hausgeräte GmbH Page 69 of 85