Reference; Displayed Messages - Yamaha SU200 Owner's Manual

Displayed Messages

The SU200 displays a number of different messages. This section explains the most important of
these messages.
Battry
Low!
Keep
PwrOn
Memory
Full!
Protct
ed
Illgal
Data!
Initializing the Memory
52

Reference

Reference
The batteries are running low and need to be replaced. For
information about how to replace the batteries, see page 12.
Upon displaying this message, the SU200 also sets on mem-
ory protection (see page 51), disabling all operations that
write new data into memory and preventing entry into job
mode. These operations remain disabled until the batteries
are replaced.
Do not switch the power off while this message is on the dis-
play. Switching the power off at this time may cause loss or
corruption of your data.
This message appears if SU200 sample memory becomes full
while sample recording or resampling is in progress.
This message appears when you attempt to carry out sample
recording, resampling, deletion, or extraction while memory
protection is ON. (To enable these operations, you must
switch protection OFF. See page 51.)
This message appears immediately following power-on if the
SU200 detects corruption in its recorded data. This type of
corruption can be caused, for example, by switching off
power while the SU200 is in the process of writing data.
The SU200 does its best to restore the bad data, but it is pos-
sible that some or all of your recorded data may be lost. If
you find that the data is very corrupted, please reinitialize
the SU200's internal memory as shown below.
BANK BANK BANK
Init
Pad-Play Mode
STANDBY
ON