Yamaha SU200 Owner's Manual page 23

N
Adjust the Recording Trigger Level.
Turn knob 2 (REC TRGLVL) to set the trigger level.
DATA REC TRGLVL
EFFECT
1
CONTROL
About the Recording Trigger Level
The illustrations below show how the trigger level works.
Sample recording starts here.
A B
As you can see, recording starts when the input level hits the recording trigger level for the first time.
At higher trigger levels, you will require a higher input level to start the recording. It is important to
avoid setting the trigger level too low: at low trigger levels, recording start may be triggered too soon by
unintentional noise (room noise, noise on the line, etc.).
M
Press the [START/STOP] button to enter recording standby.
START
STOP
<
Input the sound you are recording (through the microphone or from the device con-
nected to the LINE INPUT).
Recording starts automatically when the input level hits the trigger level.
or
"ABCDE"
>
When you have finished recording, press the [START/STOP] button to stop. The
SU200 returns to Pad-Play mode.
• Sampling automatically stops if you run out of recording time (if the remaining-time display
NOTE
falls to 00_00_0).
?
Listen to the results by pressing the pad that you selected at Step 3 above.
• If pads recorded at different grades are played together, the pad(s) recorded at lower grades
NOTE
may sound noticeably "noisy." You can avoid this problem by recording all samples at the
same grade.
• If you notice noise at the end of the sample during playback, adjust the end point to a less
noisy location.
2
Recording
trigger level
C D E
Wait
PLAY
START
STOP
Press
Start
Sample recording starts here.
A B C
ing 00_19_6
Record
ing
Remaining available recording time
Chapter 1 Recording Samples
Recording
trigger level
D E
Remaining
available
recording
time
00_19_6
23