Saving The Settings (Store) - Yamaha S90 Owner's Manual

Saving the Settings (Store)

You can store (save) your original parameter settings to
User Memory. The procedure is as follows.
When you perform this, the settings for the destination
data will be overwritten. Important data should always
be backed up to computer, a separate memory card or
some other storage device (page 82).
n When changing the Name, refer to page 34.
n The edited Mixing data can be stored by using the Put
function (page 79).
1 Press the [STORE] button after editing a Voice/
Performance. The Store screen appears.
ex. Voice
Destination Program (Voice)
2 Use [DEC/NO] and [INC/YES] buttons to select the
destination program.
3 When you press the [ENTER] button, you will be
prompted for confirmation.
n You can press the [DEC/NO] button to cancel the
Store operation and return to the original screen.
4 Press the [INC/YES] button to confirm. When it
has been completed, a "Completed" message
appears, and operation returns to the original
screen.
Never attempt to turn off the power while data is being
written to Flash ROM (while an "Executing..." or
"Please keep power on" message is shown). Turning the
power off in this state results in loss of all user data and
may cause the system to freeze (due to corruption of data
in the Flash ROM).
Plug-in Voices
Up to three Plug-in boards can be installed to the
S90. If the Plug-in Board has been correctly
installed, the corresponding SLOT lamp will light.
PROGRAM
SLOT 1
PRE 3 GM USER PLG 1
ORGAN GUITAR/ BASS STRINGS
PLUCKED
The Plug-in voices can be edited via the S90's panel
operation in much the same way as User voices.
After editing, up to 64 Plug-in voices for each Plug-
in slot can be stored.
Editing and saving Board voices
Included among the Board voices is a special set of
voices — called Board Custom voices — which can
be edited by a computer connected to the S90, using
special editing software included with the Plug-in
board.
Because the Plug-in boards do not have SRAM and
the edited voice data will be lost when turning the
power off, the edited Board Custom voice data
should be saved to a Memory Card inserted to the
S90. The Board Custom voice data saved to the
memory card can be loaded automatically when
turning the power on by using the Auto Load
function.
1 Edit the Board voice by using the Editor software.
2 Transmit the edited data to the memory
(DRAM) on the Plug-in board.
1
Edit
Computer with
application software
2
Transmit
Plug-in board
S90
Saving the Settings (Store)
SLOT 2 SLOT 3
CATEGORY
PLG 2 PLG 3
SEARCH
BRASS REED/PIPE
MUSIC SYNTHESIZER
Modular Synthesis Plug-in System
73