Attaching the RK1 rackmount kit (sold separately)
You can attach the optional RK-1 rackmount kit to the LS9-16 or LS9-32 and mount it in a rack or an
installed system.
1
Make sure that the power is turned off.
2
Remove screws "A" and detach the side pads.
NOTE
• Keep the side pad screws together with the pads you removed.
3
At the locations indicated by the arrows, tighten the screws to attach the rackmount hard-
ware.
The mixer can be attached at either of two angles, as shown in the following illustration.
4
Attach the hardware to the other side in the same way.
CAUTION
• When attaching the RK1 rackmount kit, make sure that the power is turned off. You must use the screws
that are included with the RK1.
280
LS9-16/32 Owner's Manual
Attaching the RK1 rackmount kit (sold separately)
Side pad
A
A
A
A