Basic Settings For Mix Buses And Matrix Buses - Yamaha 007POTO-G0 Owner's Manual

6
If you want to link specific parameters or
events between two LS9 consoles, proceed
as follows.
1 Move the cursor to the CASCADE LINK PORT
field, and use the dial or the [DEC]/[INC] keys to
specify the port that will transmit/receive control
signals for cascade link.
The items you can select are the same as in the
CASCADE OUT PATCH popup window (→
p. 211).
NOTE
• Control signals for cascade link and MIDI messages cannot
share the same port. If you select a port that is already speci-
fied for transmission/reception of MIDI messages, a dialog
box will ask whether it is OK to cancel the existing settings.
B Move the cursor to the CASCADE COMM LINK
field, and use the dial or the [DEC]/[INC] keys to
specify the item(s) you want to link, so that they
match the settings of the cascade slave. The items
you can select are the same as in the CASCADE
OUT PATCH popup window (→ p. 211).

Basic settings for MIX buses and MATRIX buses

This section explains how to change the basic settings for MIX buses and MATRIX buses, such
as switching between stereo and monaural, and selecting the position from which the signal is
sent from an input channel.
The settings you make in the following procedure are saved as part of the scene.
1
In the DISPLAY ACCESS section, press the
[SETUP] key repeatedly to access the SYS-
TEM SETUP screen.
1
2
3
1 BUS SETUP field
B MIX button
C MATRIX button
Using cascade connections • Basic settings for MIX buses and MATRIX buses
7
To close the INPUT PORT SELECT popup
window, move the cursor to the CLOSE but-
ton (or the × symbol in the upper right) and
press the [ENTER] key.
In this state, the bus signals of the cascade slave will
be sent via the slot to the buses of the cascade master,
and the combined signals of both buses will be output
from the cascade master. If the Cascade Link function
is enabled, the specified operations or parameter
changes performed on either LS9 console will be fol-
lowed by the other LS9 console.
2
To make MIX bus settings, move the cursor
to the MIX button of the BUS SETUP field
and press the [ENTER] key.
The MIX BUS SETUP popup window will appear.
LS9-32
1 SIGNAL TYPE (Signal processing method)
This selects whether two adjacent odd-numbered/
even-numbered MIX buses will be used as stereo
channels whose main parameters are linked (STE-
REO) or as two monaural channels (MONO × 2).
1 2
LS9-16/32 Owner's Manual
3
20
213