Yamaha 007POTO-G0 Owner's Manual page 156

Using the METER screen
D Metering point select box
Use the dial or the [DEC]/[INC] keys to select the
metering point for the input/output channels.
E Channel name
This shows the first four characters of the channel
name for the channels assigned to the [CUSTOM
FADER] layer. Channels that are not assigned are
shown as "----".
2
If desired, you can move the cursor to the
metering point select buttons and press the
[ENTER] key to switch the metering point.
In the CUSTOM FADER screen, move the
cursor to the metering point select box, use
the dial or the [DEC]/[INC] keys to make
your selection, and then press the [ENTER]
key.
The metering point for the level meters can be set
independently for input channels and output channels.
You can choose from the following metering points.
●
Input channels
• PRE HPF............Immediately before the high-
• PRE FADER .......Immediately before the fader
• POST ON ...........Immediately after the [ON] key
●
Output channels
• PRE EQ..............Immediately before the
• PRE FADER .......Immediately before the fader
• POST ON ...........Immediately after the [ON] key
For details on the metering points, refer to the block
diagram at the end of this manual.
3
If you want to hold the peak levels of the
level meters, move the cursor to the PEAK
HOLD button and press the [ENTER] key to
turn it on.
On/off operations of the PEAK HOLD button will
apply to both input channels and output channels.
When you turn this button off, the peak level indica-
tions that had been held will be cleared.
HINT
• You can also assign the PEAK HOLD button on/off function to
a user-defined key ( → p. 196).
• If you turn on METER FOLLOW LAYER in the PREFERENCE
screen, the same meter screen as the selected layer will be
displayed when you press a LAYER key.
156
LS9-16/32 Owner's Manual
pass filter
attenuator