Table of Contents
Advertisement
Effects Parameters
■ MULTI FILTER
Two input, two output 3-band multi-filter (24 dB/octave).
Parameter
Range
TYPE 1
LPF, HPF, BPF
FREQ. 1
28.0 Hz–16.0 kHz
LEVEL 1
0–100
RESO. 1
0–20
TYPE 2
LPF, HPF, BPF
FREQ. 2
28.0 Hz–16.0 kHz
LEVEL 2
0–100
RESO. 2
0–20
TYPE 3
LPF, HPF, BPF
FREQ. 3
28.0 Hz–16.0 kHz
LEVEL 3
0–100
RESO. 3
0–20
■ FREEZE
One input, two output basic sampler.
Parameter
Range
REC MODE MANUAL, INPUT
–1000 to +1000
REC DLY
ms
MOMENT,
PLY MODE
CONTI., INPUT
TRG LVL
–60 to 0 dB
TRG MASK 0–1000 ms
*1
START
END
*1
LOOP
*1
LOOP
0–100
NUM
–12 to +12 semi-
PITCH
tones
FINE
–50 to +50 cents
MIDI TRG
OFF, C1–C6, ALL
START
0–131000
[SAMPLE]
END
0–131000
[SAMPLE]
LOOP
0–131000
[SAMPLE]
*1. 0.0–5941.0 ms (fs=44.1 kHz), 0.0 ms–5458.3 ms (fs=48 kHz)
242
LS9-16/32 Owner's Manual
Description
Filter 1 type: high pass, low pass,
band pass
Filter 1 frequency
Filter 1 level
Filter 1 resonance
Filter 2 type: high pass, low pass,
band pass
Filter 2 frequency
Filter 2 level
Filter 2 resonance
Filter 3 type: high pass, low pass,
band pass
Filter 3 frequency
Filter 3 level
Filter 3 resonance
Description
In MANUAL mode, recording is
started by pressing the REC and
PLAY buttons. In INPUT mode,
Record-Ready mode is engaged by
pressing the REC button, and
actual recording is triggered by the
input signal.
Recording delay. For plus values,
recording starts after the trigger is
received. For minus values, record-
ing starts before the trigger is
received.
In MOMENT mode, the sample
plays only while the that the PLAY
button is pressed. In CONT mode,
playback continues once the PLAY
button has been pressed. The
number of times the sample plays
is set using the LOOP NUM param-
eter. In INPUT mode, playback is
triggered by the input signal.
Input trigger level (i.e., the signal
level required to trigger recording
or playback)
Once playback has been triggered,
subsequent triggers are ignored for
the duration of the TRG MASK
time.
Playback start point in milliseconds
Playback end point in milliseconds
Loop start point in milliseconds
Number of times the sample plays
Playback pitch shift
Playback pitch shift fine
PLAY button can be triggered by
using MIDI Note on/off messages.
Playback start point in samples
Playback end point in samples
Loop start point in samples
■ STEREO REVERB
Two input, two output stereo reverb.
Parameter
Range
REV TIME
0.3–99.0 s
Reverb time
Hall, Room, Stage,
REV TYPE
Reverb type
Plate
INI. DLY
0.0–100.0 ms
Initial delay before reverb begins
HI. RATIO
0.1–1.0
High-frequency reverb time ratio
LO. RATIO
0.1–2.4
Low-frequency reverb time ratio
Reverb diffusion (left–right reverb
DIFF.
0–10
spread)
DENSITY
0–100%
Reverb density
Balance of early reflections and
E/R BAL.
0–100%
reverb (0% = all reverb, 100% =
all early reflections)
THRU, 21.2 Hz–
HPF
High-pass filter cutoff frequency
8.00 kHz
50.0 Hz–16.0 kHz,
LPF
Low-pass filter cutoff frequency
THRU
■ M. BAND DYNA.
Two input, two output 3-band dynamics processor, with
individual solo and gain reduction metering for each band.
Parameter
Range
LOW GAIN –96.0 to +12.0 dB
MID GAIN
–96.0 to +12.0 dB
HI. GAIN
–96.0 to +12.0 dB
PRESENCE
–10 to +10
L–M XOVR
21.2 Hz–8.00 kHz
M–H XOVR 21.2 Hz–8.00 kHz
SLOPE
–6 dB, –12 dB
CEILING
–6.0 dB to 0.0 dB, OFF
CMP. THRE –24.0 dB to 0.0 dB
CMP. RAT
1:1 to 20:1
CMP. ATK
0–120 ms
CMP. REL
*1
CMP. KNEE 0–5
CMP. BYP
OFF/ON
LOOKUP
0.0–100.0 ms
EXP. THRE
–54.0 dB to –24.0 dB
1:1 to ∞:1
EXP. RAT
*1
EXP. REL
EXP. BYP
OFF/ON
LIM. THRE
–12.0 dB to 0.0 dB
LIM. ATK
0–120 ms
LIM. REL
*1
LIM. KNEE
0–5
LIM. BYP
OFF/ON
*1. 6.0 ms–46.0 s (fs=44.1 kHz), 5.0 ms–42.3 s (fs=48 kHz)
Description
Description
Low band level
Mid band level
High band level
For positive values, the thresh-
old of the high band is low-
ered and the threshold of the
low band is increased. For
negative values, the opposite
will occur. When set to 0, all
three bands are affected the
same.
Low/mid crossover frequency
Mid/high crossover frequency
Filter slope
Specifies the maximum output
level
Compressor threshold
Compressor ratio
Compressor attack
Compressor release time
Compressor knee
Compressor bypass
Lookup delay
Expander threshold
Expander ratio
Expander release time
Expander bypass
Limiter threshold
Limiter attack
Limiter release time
Limiter knee
Limiter bypass
Advertisement
Table of Contents
