Panasonic FP7 Series User Manual page 107

Constant scan error
SRF
flag
WS1
Device
number
SR10 Normally-on relay
SR11 Normally-off relay
SR12 Scan relay
SR13 Initial pulse relay (ON)
SR14 Initial pulse relay (OFF)
Stepladder
SR15
Initial pulse relay (ON)
SR16 PB initial relay (ON)
SR17 PB initial relay (OFF)
0.01-second clock pulse
SR18
relay
0.02-second clock pulse
SR19
relay
0.1-second clock pulse
SR1A
relay
0.2-second clock pulse
SR1B
relay
SR1C 1-second clock pulse relay
SR1D 2-second clock pulse relay
SR1E 1-minute clock pulse relay
SR1F Not used
Turns on if scan time exceeds the setting during constant scan. It
also turns on if '0' is set in FP7 configuration.
Name
Is normally on.
Is normally off.
Turns on or off in each scan.
Goes on for only the first scan after operation (RUN) has been
started, and goes off for the second and subsequent scans.
Goes off for only the first scan after operation (RUN) has been
started, and goes on for the second and subsequent scans.
Turns on in the first scan only, following startup of any single
process, during stepladder control.
Turns on at the start of execution of a program block. Turns off in
the next scan.
Turns off at the start of execution of a program block. Turns on in
the next scan.
Clock pulse with a 0.01-second cycle
Clock pulse with a 0.02-second cycle
Clock pulse with a 0.1-second cycle
Clock pulse with a 0.2-second cycle
Clock pulse with a 1-second cycle
Clock pulse with a 2-second cycle
Clock pulse with a 1-minute cycle
8.1 CPU Unit Specifications
Description
8-11