Advertisement
Step
20
Wait approximately 5 minutes, then
connect the laptop to the service jack on the
front of the TN2314 Processor board.
LT-IE – Connect to the TN2314 processor
21
with Internet Explorer.
22
LT-IE – Open the S8100's desktop.
Note: Terminal server client and terminal
services Active X must be installed on the
laptop. The easiest way to do this is to
upgrade your Windows 95 laptop's browser
to Internet Explorer 5.5.
SDT – On the S8100's desktop,
23
double-click the time display and set the
time, time zone, date, and Daylight Savings.
24
SDT – Disable modem compression.
25
SDT – Open a bash shell window.
26
BS – Verify the software's version.
Upgrade Job Aids for S8100
November 2003
Replacing an S8100 Media Server to upgrade its software from R9.5
a
Connect a cable from the laptop's PCMCIA Ethernet
card to an RJ45 coupler.
b
Connect a cross-over (flip) cable from the coupler to
the RJ45 service jack on the front of the TN2314
Processor board.
Open Internet Explorer on the laptop, type 192.11.13.6 in the
URL address bar, and press Enter.
a
Click 'Administer System' and login using lucent3
for login and password. A domain is not required.
Select 'continue' at license agreement window.
b
Select 'Login to <xxx>' under Remote Control –
Terminal Services (where <xxx> is the host name used
for this system).
c
If a VBScript error message appears, click OK.
d
Click the Connect button (leave the Server field
blank).
e
If a VBScript message appears, click OK (you can
resize the Terminal Services screen to full size by
pressing ctlr-alt-Pause). A login window will open.
f
Login using lucent3. After login, the S8100's
Windows 2000 desktop is displayed.
The time display is in the tool tray at the lower right of the
desktop.
Click Start → Settings → Control Panel.
a
b
Double-click Phone and Modem Options.
c
Click the Modems tab.
d
Select the installed modem and click Properties.
e
Click the Advanced tab.
f
Click Change the Default Preferences.
g
In the Compression drop-down list, select Disabled.
Close each dialog by clicking OK, and close the
h
Control Panel window.
Click Start → Run → bash.
Type swversion. Ensure that the Release number and
MultiVantage version number are as expected.
Upgrade steps
Details
23
Advertisement
