Advertisement
Upgrade steps
Step
1
For a direct connection between the
technician's laptop and the S8100's service
port:
LT – Change laptop's IP address to
192.11.13.5
LT-IE – Disable proxy servers on Internet
2
Explorer.
3
Connect the laptop to the R9.5 Processor
board (TN795).
LT – Connect to the TN795 processor.
4
5
LAC – Open a bash shell by typing bash at
the LAC prompt.
BS – Important! – Display and record the
6
customer's network and product
information.
7
BS – Shutdown AUDIX.
BS – Exit the bash shell and return to the
8
LAC prompt.
9
LAC – Open a SAT window.
Upgrade Job Aids for S8100
November 2003
Replacing an S8100 Media Server to upgrade its software from R9.5
a
Right-click the 'Network Neighborhood' {My
Network Places} icon on the laptop's desktop and
select Properties.
b
{Right-click 'PCMIA Ethernet Connection' (or Local
Area Connection) and select Properties.}
c
Highlight the TCP/IP icon from the popup window
and select Properties. Check the 'Specify an IP
address' {'Use the following IP address'} radio
button.
Enter 192.11.13.5 in the IP address field and
d
255.255.255.252 in the subnet mask field, and click
OK to close the popup windows.
a
Open Internet Explorer and select Tools, Internet
Options, the Connections tab, and LAN Settings.
b
Uncheck the 'Use a proxy server' radio button, and
click OK to close the popup windows.
a
Connect a cable from the laptop's PCMCIA Ethernet
card to an RJ45 coupler.
b
Connect a cross-over (flip) cable from the coupler to
the PCMCIA network-interface card in the TN795's
PCMCIA slot.
Click Start, Run, and enter telnet 192.11.13.6.
a
Log in using lucent3. – The LAC prompt displays.
b
Type bash at the LAC prompt.
a
From the bash shell, execute the following three
commands – setip, productid, oss.
Write down all of this information exactly as it
b
appears on the screen. You will need to re-enter
this information later.
Type shutdown audix. When the BASH prompt returns
(the Audix shutdown takes a few minutes), type statapp to
verify that AUDIX has shutdown.
Type exit.
Type definity to open a SAT window. (The terminal type is
'NTT' {'W2KTT'}.)
Upgrade steps
Details
21
Advertisement
