Gearbox - Baroness TDA1200 Service Manual

TDA1200・TDA1600
Operating Machine and Mower Units

Gearbox

Gear box layout
Gear box layout_001
1
2
3
Inspection of gear box
According to frequency of use, the bearings,
bevel gear, gear and etc. can become worn
and damaged. If the gearbox does not
operate smoothly check and inspect bearings,
bevel gear, gear and other parts for wear,
cracks or damage and replace where
necessary.
Check for cracks on the gearbox.
･
Check bearing for wear and rust.
･
Check bevel gear for wear, cracking or
･
chipping.
On drive shafts A and B, check splines for
･
wear, cracks and scratches.
Check that there is no wear in the key
･
grooves on drive shaft C.
Check there is no abnormality in both keys.
･
Check the wear on each stop ring.
･
Do not re-use spring pin, O-ring, oil seal
･
and seal washer, replace with new ones.
Important
Always replace spring pin, O-ring, oil seal and
seal washers with new ones.
Page 4-44
2 3 2
1 1
Slotted nut 20 and cotter pin for drive
shaft
Slotted nut 24 and cotter pin for crank
shaft
Gearbox
1. Remove 14 plug and 14 seal washer from
gear box and drain oil.
1
2
dykztf-001
2. Make sure the change lever is in the low
position.
3. Remove U nut and washer from 2 places
on the shift lever. At shift fork, remove bolt,
compression spring A and washers. At the
bottom of the change lever remove bolt and
washer.
Inspection of gear box_001
1 Gearbox
2 14 plug, 14 seal washer
Inspection of gear box_002
1 Change lever
2 Shift fork
A Shift position (LOW speed)
1
3
4
5
6
Inspection of gear box_003
Inspection and repair of each section
5s6or7-030
1
A
2
5s6or7-031
2
5s6or7-032