Crank Housing - Baroness TDA1200 Service Manual

TDA1200・TDA1600
Operating Machine and Mower Units
23. Drive it in by using a wooden hammer to
prevent any damage on the thread.
Inspection of crank Assy_018
24. Install the two double round head keys.
Inspection of crank Assy_019
1
Important
When tightening the slotted nut, fasten it with
a specified torque after installing the crank
Assy to the main body, and then install the
cotter pin.
See "Crank Assy layout" (Page 4-10) .
25. Install the disc spring and cotter nut, and
temporarily tighten the nut.
Inspection of crank Assy_020
Page 4-42
ogzg3t-018
1
ogzg3t-019
Double round head key
3
2
1
ogzg3t-020
1
2
3
26. Install two bolts, nuts, and spring washers,
tighten them until the bolts hit the keys, and
lock them with nuts.
27. Install the other crank Assys in the same
way.

Crank housing

Crank housing layout
1
Crank housing layout_001
1
Inspection of crank housing
Wear of bearings due to frequent usage and
invasion of water may damage bearings etc.
and prevent smooth rotation of the roller.
Inspect and replace the parts such as the
bearings.
Make sure that the housing does not have
･
any chap or crack.
Make sure that there is no wear or damage
･
of the shaft.
Make sure that there is no wear or rust of
･
the bearing.
Make sure that there is no play in the fit of
･
the shaft and the bearing.
1. Remove the crank Assy from the machine.
See "Removal of crank Assy" (Page 4-11) .
Inspection and repair of each section
Disc spring
Slotted nut
Bolt, nut, and spring washer
1
onpou8-001
Crank housing