Crank Assy - Baroness TDA1200 Service Manual

TDA1200・TDA1600
Operating Machine and Mower Units
23. Drive the bearing by using a driver and
install the stop rings to both sides of it.
24. Push the urethane collar into the bearing.
1
Inspection of spring box_018
1
2
3
25. Install the box fixing collars into both sides
of the spring box.
Inspection of spring box_019
1
Page 4-38
2
3
pue9kj-017
Bearing
Stop ring
Urethane collar
1
pue9kj-018
Box fixing collar

Crank Assy

Inspection of crank Assy
Wear of bearings due to frequent usage and
invasion of water may damage bearings etc.
and prevent smooth rotation of the roller.
Inspect and replace the parts such as the
bearings.
Confirm that there is no crack in the upper
･
housing, crank bracket, and crank bracket
A.
Make sure that there is no wear or damage
･
of the drive shaft nor crank shaft.
Make sure that there is no wear or rust of
･
the bearing.
Make sure that there is no play in the fit of
･
the shaft and the bearing.
Confirm that there is no play in the upper
･
housing nor bearing.
Confirm that there is no play in the crank
･
bracket, crank bracket, nor drive shaft.
1. Remove the crank Assy from the machine.
See "Removal of crank Assy" (Page 4-11) .
2. Remove the cotter pin from the cotter pin
from the slotted nut, and then the slotted
nut and disc spring.
See "Crank Assy layout" (Page 4-10) .
1
Inspection of crank Assy_001
1
2
Inspection and repair of each section
2
ogzg3t-001
Crank Assy
Slotted nut and disc spring