Lifting
Lifting point
Warning
When repairing the front roller or any parts
related to the roller, place the machine on a
solid flat floor such as concrete and remove
any obstacles for safe work before lifting the
machine.
To lift the machine, use the appropriate hoist
and chain block.
Especially when replacing the front roller
brackets (L) and (R), be sure to securely
support the machine at the four points using
jack stands.
If it is not supported securely, the machine
may move or fall.
It may cause injury or death.
Use an adequately strong lifting sling.
The machine shall be lifted at the lifting point
and fixed in the positions described in the jack
stand points.
Do not lift nor place the machine on the jack
stands in any other positions than the specified
ones.
Doing so, the frames and parts may get
damaged.
Lifting point and jack stand point
1.
Lifting point
Front frame and rear frame
Caution
Attach the slings to the front and rear frames
as shown in the figure, and lift them with
keeping the left and right sides well balanced.
3
Lifting point and jack stand point_001
Lifting
Maintenance standards and maintenance
4
1
2
i5i6y1-001
1
Front frame
2
Rear frame
3
Lifting point
4
Sling
2.
Jack-stand points
[1]
Rear frame pipe
Caution
Place the jack stands in the specified places.
3
Lifting point and jack stand point_002
1
Rear frame pipe
2
Jack stands
3
Jack-stand points
[2]
Box mounting bracket
Caution
Place the jack stands in the specified places.
Lifting point and jack stand point_003
1
Box mounting bracket
2
Jack stands
3
Jack-stand points
TDA1200・TDA1600
3
1
2
i5i6y1-002
1
3
2
i5i6y1-003
Page 3-7