Removal And Installation Of Each Section; Φ12.Φ18 Tine Mounting Board - Baroness TDA1200 Service Manual

TDA1200・TDA1600
Operating Machine and Mower Units
Removal and installation of each
section
φ12.φ18 tine mounting board
Removal of φ12.φ18 tine mounting board
Warning
When removing or installing any crank parts,
be sure to secure the crank.
If the crank is not secured, the crank may
become unbalanced and rotate suddenly.
It may cause injury or death.
･ The machine is removed from the tractor
with its upper link, up-down handle, and
cover removed.
1. Remove the φ12.φ18 tine mounting board
from the tine holder.
Removal of φ12.φ18 tine mounting board_001
1
2
2.
[1] Turn the crank and place the tine holder
on a stage, so that the φ12.φ18 tine
mounting board can be removed from
that tine holder.
Page 4-6
1
2
gd7xfv-001
Tine holder
φ12.φ18 tine mounting board
[2] Install the socket on the spinner handle,
and remove the two bolts and the
φ12.φ18 tine mounting board.
3
2
4
Removal of φ12.φ18 tine mounting board_002
1 Tine holder
2 Bolt and spring washer
3 φ12.φ18 tine mounting board
4 Stage
3. Remove the other φ12.φ18 tine mounting
boards in the same way.
1
Removal of φ12.φ18 tine mounting board_003
The condition after the φ12.φ18 tine
1
mounting board is removed
The condition with the φ12.φ18 tine
2
mounting board installed

Removal and installation of each section

1
gd7xfv-002
2
gd7xfv-003