TDA1200・TDA1600
Operating Machine and Mower Units
9.
Remove the rear roller by sliding it to the
right.
1
Removal of rear roller Assy_008
1
Installation of rear roller Assy
Caution
Refer to "Tightening torques" (Page 3-4) .
Note that the Baroness product warranty may
not apply to any defects caused by incorrect
or overtorque tightening, etc.
For installation, reverse the removing
procedure.
Front roller bracket
Removal of front roller bracket
1.
Install the sling to the rear frame and lift it
with a hoist, etc. until the rear roller lifts off
the ground.
1
3
Removal of front roller bracket_001
1
2
3
Page 4-22
oxwlid-008
Rear roller
2
oxwlid-001
Rear frame
Sling
Rear roller
2.
Remove snap pin A and the flat-head pin
securing the rear roller Assy.
Follow the same steps to remove those on
the other side.
2
Removal of front roller bracket_002
1
Rear roller Assy
2
Snap pin A and flat-head pin
3.
Remove the bolt, washer, and U nut and
then remove the bracket mounting board.
Follow the same steps to remove those on
the other side.
1
Removal of front roller bracket_003
1
Bolt, washer, and U nut
2
Bracket mounting board
4.
Place the jack stands under the rear frame
pipe.
Removal of front roller bracket_004
Removal and installation of each section
1
kqszfp-001
2
oxwlid-007
1
2
kqszfp-002