Gearbox - Baroness TDA1200 Service Manual

Gearbox

Gear box layout
Gear box layout_001
Slotted nut 20 and cotter pin for drive
1
shaft
Slotted nut 24 and cotter pin for crank
2
shaft
3 Gearbox
Removal of gear box
Warning
When removing or installing any crank parts,
be sure to secure the crank.
If the crank is not secured, the crank may
become unbalanced and rotate suddenly.
It may cause injury or death.
The machine is removed from the tractor
･
with its upper link, up-down handle, and
cover removed.
1. Remove the upper arms from the left and
right sides of the gear box. (See "Removal
of lower housing Assy" (Page 4-7) .)
2. Remove the cotter pin from the slotted nut
of the crank shaft. (See "Gear box layout"
(Page 4-15) .)
3
2
Removal of gear box_001
Removal and installation of each section
Operating Machine and Mower Units
2 3 2
1 1
dykztf-001
1
3
usrzwg-001
1 Gearbox
2 Upper arm
3 Slotted nut and cotter pin
Caution
When removing and installing the crank nuts,
be sure to secure the crank.
3. Secure the crank bracket by using a wood
block, etc. so that it does not rotate when
the nuts are loosen.
4. Loosen the cotter nut of the crank shaft.
3
5
Removal of gear box_002
1 Crank
2 Wood block
3 Spanner
4 Slotted nut for crank shaft
5 Slotted nut for drive shaft
5. Remove the cotter pins from the slotted
nuts of the left and right drive shafts. (See
"Gear box layout" (Page 4-15) .)
Caution
When removing and installing the crank nuts,
be sure to secure the crank.
6. Secure the crank bracket by using a wood
block, etc. so that it does not rotate when
the nuts are loosen.
7. Loosen the cotter nuts of the left and right
drive shafts.
TDA1200・TDA1600
2
1
4
usrzwg-002
Page 4-15