Rear Roller Assy - Baroness TDA1200 Service Manual

TDA1200・TDA1600
Operating Machine and Mower Units
3. Remove the bolt and spring washer.
Follow the same steps to remove those on
the other side.
1
Removal of front roller Assy_003
1
2
4. Lift the main body up by using a hoist, etc.
Removal of front roller Assy_004
1
5. Remove the flange unit by using a pulley
puller.
2
Removal of front roller Assy_005
1
2
Page 4-20
2
Flange unit
Bolt and spring washer
1
Main body
1
Pulley puller
Flange unit
Installation of front roller Assy
Caution
Refer to "Tightening torques" (Page 3-4) .
Note that the Baroness product warranty may
not apply to any defects caused by incorrect
or overtorque tightening, etc.
For installation, reverse the removing
procedure.

Rear Roller Assy

jupx7f-003
Removal of rear roller Assy
1. Install the sling to the rear frame and lift it
with a hoist, etc. until the rear roller lifts off
the ground.
3
jupx7f-004
2. Remove the bolt, spring washer and
washer, and then remove the scraper.
1
jupx7f-005
Removal and installation of each section
1
2
Removal of rear roller Assy_001
1 Rear frame
2 Sling
3 Rear roller
2
Removal of rear roller Assy_002
1 Scraper
2 Bolt, spring washer, and washer
oxwlid-001
oxwlid-002