TDA1200・TDA1600
Operating Machine and Mower Units
3.
Remove the spring box at the lowest point
in the following procedure:
1
Removal of spring box_002
1
[1]
Remove the bolts and spring washers
from the tine holder.
1
Removal of spring box_003
1
2
3
[2]
Remove the nut and bolt from the box
mounting bracket and then remove the
spring box.
4
2
Removal of spring box_004
Page 4-10
m4y46a-001
Spring box
2
3
mgo9ef-003
Tine holder
Spring box
Bolt and spring washer
1
3
m4y46a-002
1
2
3
4
4.
When removing the spring box after that,
attach the sling to the crank housing at the
highest point after setting the spring box to
be removed at the lowest point, and follow
the same procedure.
Installation of spring box
Caution
Refer to "Tightening torques" (Page 3-4) .
Note that the Baroness product warranty may
not apply to any defects caused by incorrect
or overtorque tightening, etc.
For installation, reverse the removing
procedure.
Crank Assy
Crank Assy layout
2
1
3
Crank Assy layout_001
1
2
3
Removal and installation of each section
Box mounting bracket
Nut
Bolt
Spring box
2
2
3
2
1
1
2
1
Slotted nut 20 and cotter pin for drive
shaft
Slotted nut 24 and cotter pin for crank
shaft
Crank Assy
zilztg-001