Network Management; General; Ethernet Speed Setting - Xerox WORKCENTRE 7428 System Administrator Manual

Network Management

General

Ethernet Speed Setting

The printer's Ethernet Interface has speed settings of Auto (10/100Base-TX, 100Base-TX (Half or Full
Duplex), and 10Base-TX (Half or Full Duplex). By default the Ethernet Port Configuration is set to Auto.
To Change the Network Speed
1. Press the Log In/Out button on the control panel.
2. Enter the System Administrator's Login ID and Passcode if prompted (default admin, 1111), and
press Enter.
3. Press the Machine Status button.
4. Touch the Tools tab.
5. Press Connectivity & Network Setup.
6. Press Protocol Settings.
7. When the Protocol Settings menu displays, the selection line labeled Ethernet Rated Speed.
8. Press the Change Settings button.
9. On the Ethernet Rated Speed screen note which one of the buttons is highlighted as the current
setting for Ethernet speed. The available settings are Auto (default), 100 Mbps Full Duplex, 100
Mbps Half Duplex, 10 Mbps Full Duplex, 10 Mbps Half Duplex.
10. To change settings, press your setting of choice, then press the Save button.
11. To exit the Ethernet Setting screen, without making any changes, press the Cancel button.
12. To exit the Protocol Settings menu, returning to the Tools tab, press the Close button.
13. Wait several seconds and the Auto Clear service should log you out.
Note: Note that if you changed any settings in the Protocol Settings menu, the printer will
automatically reboot to register and enable your new settings.
42 WorkCentre 7425/7428/7435
System Administrator Guide