Xerox WORKCENTRE 7428 System Administrator Manual page 53

Viewing or Configuring the SMB Host Name or WINS Server
1. Open your Web browser and enter the IP address of the printer in the address field. Press Enter to
open CentreWare Internet Services.
2. Click the Properties tab.
3. Enter the system administrator User Name and Password (default admin, 1111) if prompted.
4. Click the Properties Tab.
5. Click the Connectivity folder, then the Protocols folder.
6. Select Microsoft Networking in the directory tree.
7. The available selections include:
• Transport
• Maximum Connections
• Workgroup Name
SMB Host Name
•
TBCP Filter: (Displayed when PostScript is enabled).
•
• An enabling check box for supporting Unicode (supplying the Host name and Workgroup name
in Unicode characters during SMB transmission).
• An enabling check box for Auto Master Mode. When the master browser for the workgroup
cannot be found, if this box is checked, this host will become the master browser.
• An enabling check box for Password Encryption (during SMB transmission).
• WINS Server: For using a WINS Server to resolve NetBIOS names (SMB host names) to IP
addresses.
8. Select TCP/IP from the Transport menu.
9. Accept the default value, or enter a value from 3 to 10, for maximum number of connections
allowed in Maximum Connections.
10. Accept the Workgroup name shown, or enter your own workgroup name.
11. Either accept the default SMB Host Name, which is automatically built by the printer to assure the
name's uniqueness, or enter your preferred name. Note that this will be the NetBIOS name that is
resolved by the Naming Server (DNS or WINS) to an IP Address for the printer.
12. If using a WINS server, enable the WINS Server Address Resolution check box. When enabled, the
printer will contact the DHCP Server for the IP Addresses of the Primary and Secondary WINS
(Windows Internet Naming Service) Servers. Note that two IP Address lines, with entry boxes, are
provided for manual entry (when DHCP is not selected).
13. To apply setting changes, click the Apply button, then click the Reboot button to reboot the printer.
To exit without making any changes, click the Undo button.
Note: To use the printer's NetBIOS name over the TCP/IP Network, the DNS and WINS Servers must be
configured for NetBIOS name to IP address resolution. Also, make sure that the printer is informed of
the addresses of the DNS/WINS Servers. For more information see
page 48 and Microsoft (NetBIOS over IP) Networks
Setting Up a Computer to Print Directly to the printer
See Microsoft (NetBIOS over IP) Networks
on page 52.
on page 52.
Microsoft (NetBIOS over IP) Networks
TCP/IP Dynamic Addressing
WorkCentre 7425/7428/7435
System Administrator Guide
on
53