Advertisement
2. Center punch the new mower deck hole locations using
the 3 holes in the template
3. Remove the metal template and drill 3 pilot holes (1/8
inch) with a sharp drill bit
4. Drill 3 holes (13/32 inch) holes into the pilot holes
with a sharp drill bit
Figure 6
1. Mower deck
2. Drill 3 pilot holes (1/8 inch)
here.
3. Template with the number
60 in it
5. Install the new blower hinge with 3 bolts (3/8 x 1
inch) and 3 locknuts (3/8 inch) using the drilled holes
(Figure
7).
6. Install the anti-scalp roller to the blower hinge with
the previously removed axle bolt (3/8 x 4-1/2 inches),
spacer, bushing, and flange nut (3/8 inch); refer to
Figure
7.
(Figure
6).
(Figure
6).
(Figure
6).
4. Template location on
mower deck
5. Nut
6. Carriage bolt
1. Mower deck
4. Bolt (3/8 x 4-1/2
2. Bolt (3/8 x 1
5. Spacer
inch)
3. Locknut (3/8
6. Anti-scalp roller 9. Drilled holes
inch)
5
Figure 7
7. Bushing
inch)
8. Blower hinge
assembly
Advertisement
