Advertisement
7. After the new pulley assembly is in position, install the
mower deck belt onto the lower pulley.
Figure 2
1. Pulley nut
2. Washer
3. Double pulley assembly
4. Mower deck
3
Removing the Existing
Anti-Scalp Roller and Bracket
(For 60-inch Decks Only)
No Parts Required
Procedure
1. Clean the area around the right, rear anti-scalp wheel.
2. Remove the anti-scalp roller from the bracket by
loosening and removing the flange nut (3/8 inch) and
axle bolt (3/8 x 4-1/2 inch) as shown in
3. Remove the 3 carriage bolts (3/8 x 3/4 inch) and flange
nuts (3/8 inch) securing the bracket to the mower
(Figure
3).
Note: Save all hardware for later use.
1. Anti-scalp roller
2. Anti-scalp bracket
3. Bolt (3/8 x 4-1/2 inch)
3
Figure
Figure 3
4. Carriage bolt (3/8 x 3/4
inch)
5. Flange nut (3/8 inch)
6. Mower deck
3.
Advertisement
