Advertisement
Figure 10
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Slide the blower assembly peg into the pivot hole
(Figure
11).
Figure 11
Model 31213 shown
1. Blower assembly
2. Mower deck
3. Close the blower assembly to see if the latches are
adjusted correctly. Loosen or tighten the bolt so that
the latches firmly hold the blower assembly against the
mower deck but can be released by hand
5. Spring installed
6. Grass deflector
7. L-end of spring; place
it behind the deck edge
before installing the bolt.
8. J-hook end of spring
3. Pivot hole
4. Blower assembly peg
(Figure
12).
Model 31213 shown
1. Latch
2. Bolt
4. Install the spring as shown in
Note: Make sure that the hooks are in the correct
position.
1. Spring-loaded idler pulley
2. Short hook end
5. Pull the spring-loaded idler pulley back and route the
belt around the mower deck pulley. Ensure that the
belt is routed around the blower pulleys correctly
(Figure
14).
7
Figure 12
3. Blower assembly
Figure
13.
Figure 13
3. Long hook end
Advertisement
