Table of Contents
Advertisement
'\
/
Appendix B. Problem Checklist and Setup Error Codes
Problem Checklist
If the Os and Ps on your display do not match the information that is filled in on
the IBM 5294 Setup Form, perform the following checks:
1.
Make sure all the attaching display stations and printers are set up.
2.
Make sure the Power switch on each attaching display station and printer is
set to On.
3.
Make sure all the cables connecting to the ports on the 5294 are connected
and are securely fastened. Also make sure the cables are securely fastened
at the other end.
4.
Make sure the work station address of each work station is set correctly. If
you are unsure of any workstation address, contact your planner.
5.
Check the Terminator switch on any work station that has one. Make sure it
is set correctly. (Refer to Appendix C for the location of the Terminator
switches.)
2
-
-
-
-
•
T
If
two cables are
connected, set the
Terminator switch
to
2.
-
•
-
-
•
T
If
one cable is
connected, set the
Terminator switch
to
1.
OR
-
-
-
•
•
T
Display stations and
printers with only
one socket do not
have Terminator
switches.
6.
After you have checked all of the above, repeat Steps 3.1 through 3.7 in
Chapter 3.
If your display still does not match the layout display, contact your planner and
report the problem.
Appendix B. Problem Checklist and Setup Error Codes
61
Advertisement
Table of Contents
