Customer Setup Error Codes - IBM 5294 Setup Procedure

Customer Setup Error Codes
If a blinking four-digit error code appears in the lower left corner of your display
during the setup procedure, refer to the following chart for an explanation and
recovery procedure.
Error Meaning and
Code Recovery Procedure
0080
The information you just entered in the entry fields has been
somehow altered and must be entered again.
To recover, set the Power switch on the 5294 to
Off
and repeat 2.12
through 3.31.
0081 There are more than the maxim-um number of work stations attached
to your 5294 Control Unit. (An E should appear on your display for
every extra display station attached.)
To recover, disconnect the extra work stations. Contact your planner
for assistance.
0082
The keyboard code you just entered is not valid for your configura-
tion.
To recover, make sure the information on your display matches the
information that is tilled in on the IBM 5294 Setup Form. If it matches,
contact your planner and report an invalid keyboard code.
0083
You tried to enter a keyboard code for a printer or at a location where
no display station exists. (You can enter keyboard codes only beside
Os on the display.)
To recover, make sure you have the correct address and port number
of the display station and enter the keyboard code again.
0084 Contact your IBM service representative to recover from this error.
0086 You tried to use the magnetic stripe reader or the selector light pen at
your display station but the Expanded Function feature that supports
those devices either is not installed in the 5294 or is not working.
62 Control Unit Setup Procedure
To recover, make sure the Expanded Function feature was ordered
and installed in the 5294.
If you are sure the feature was ordered and installed, contact your
IBM service representative.
If it was not ordered and installed but should have been, contact your
IBM sales representative.