Setting The Display - IBM 5294 Setup Procedure

Setting the Display
Your controller should have the Power switch set to On and the Test/Normal
switch set to Test.
ALL THE WORK STATIONS (DISPLAY STATIONS AND PRINTERS) MUST BE
POWERED ON DURING THIS PROCEDURE. The 5294 will not recognize any
work stations that are not powered on.
Note: Refer to the IBM Multistation 5550-5250 Personal Computer User's Guide
for the key location.
Make sure ALL the work stations (display stations and
printers) attaching to your controller are powered on.
Go to the display station closest to the controller.
Press the Error Reset
I I§I
J
key and continue to step
~
EJ (]
0
[J (J
0 () [) 0
[l [J [)
w
DlEJllEJ lCEIJ
~ ~
[6J[) EJ [) EJ
[J [)
EJ
0 [) [] O(][]JgO EJ [) EJ
bJ EJ
DEJDrJ
EJ 0 []
EJ [) () [)
0 0 0 DBEJ [)
EJ~
~ ~
OEID lJ
[J [) [) [) [J
EJ [) 0 0
[)(EJIJ
EJ
[J [) [J
~'"
EJ EJ [
1\
Il l l i J l
]I
IE]
]I
101
1
18 Control Unit Setup Procedure