Chapter 3. Setup And Operation Of An Ibm 5394 With A V.35 Communications Interface; Before Setup Checklist - IBM 5394 Manual

Chapter 3. Setup and Operation of an IBM 5394 with a V.35
Communications Interface
Use this chapter if you are responsible for setting up, configuring, and operating
the IBM 5394 Remote Control Unit with a V.35 communications interface.
This chapter contains the following information about the V.35 communications
interface:
• Items you need to set up the IBM 5394
• Specific modifications to the setup procedure
• A new extended test procedure.
Using a V.35 communications interface does not affect other procedures and infor-
mation in the IBM 5394 Remote Control Unit Setup Guide or the IBM 5394 Remote
Control Unit Operator's Guide and Problem Determination Procedures.
Before Setup Checklist
Answer the following questions. If the answer to any of the questions is no, or if
you are not sure, contact the person who planned your communications network.
Check the box as you complete each step. Make sure this checklist is complete
before you begin setup.
D
Do you have the following equipment?
D
An IBM 5394 Remote Control Unit Model 01C
D
At least one display station that is not an IBM PC using AS/400 PC
Support or IBM Personal System/2® using AS/400 PC Support
D
V.35 communications cable
D
5394 system diskette at release level 1.1 or higher and backup diskette
D
Modem or DCE with V.35 support
D
Power cord
D
Labeled work station cables.
D
Do you have a completed Control Unit Setup Worksheet and completed
Remote Work Station Setup Worksheets?
Note: Do not attempt setup without these worksheets. You can find copies
of these worksheets and instructions for completing the worksheets in the
IBM 5394 Remote Control Unit Introduction and Installation Planning Guide.
® Personal System/2 is a registered trademark of International Business Machines Corporation.
Chapter 3. Setup and Operation of an IBM 5394 with a V.35 Communications Interface
5