Connection Overview - SonicWALL SuperMassive 9200 Getting Started Manual

Connection Overview
Connect a WAN port (X8 shown here) on your SonicWall
SuperMassive appliance to the LAN port on your existing
Internet gateway device. Then connect the X0 port on your
SonicWall appliance to your LAN resources.
SonicWall SuperMassive
10GE 1GE
X18 X16 X14 X12 X10 X8
SDHC
M0
ALARM
TEST
SonicWALL SuperMassive 9600
PWR 1 PWR 2
CONSOLE MGMT X19 X17 X15 X13 X11 X9
X0
Network Resources
48 SonicWall SuperMassive 9200/9400/9600 Getting Started Guide
Network Gateway
LAN
1GE
X6 X4 X2 X0
L2 Bridge Link
BYPASS
STATUS
X7 X5 X3 X1
X8
Configuring the Primary Bridge
Interface
The primary bridge interface is connected to your existing
Internet gateway device. The requirements for the primary
bridge interface are:
• The interface is in the WAN zone.
• The interface has a static IP address.
Internet or
• The interface is not a member of a WAN Load Balancing
LAN Segment 2
group, such as the Default LB Group.
NOTE: The X1 WAN interface is automatically a member
of the Default LB Group. For best results, configure
another WAN interface for use as the primary bridge
interface.