Configuring the Secondary Bridge
Interface
1 In SonicOS, navigate to the Network > Interfaces page.
2 Click the Configure icon for the X0 (LAN) interface.
3 In the Mode / IP Assignment drop‐down list, select
Layer 2 Bridged Mode.
4 In the Bridged to drop‐down list, select the WAN zone
interface that you configured as the primary bridge
interface.
5 Optionally enable the Block all non‐IP traffic setting to
prevent the L2 bridge from passing non‐IP traffic.
NOTE: Do not enable Never route traffic on this bridge‐
pair unless your network topology requires that all
packets entering the L2 Bridge remain on the L2 Bridge
segments.
6 Enable the desired Management options (HTTPS, Ping,
SNMP, SSH).
7 Enable the desired User Login options (HTTP, HTTPS).
8 Optionally enable the Add rule to enable redirect from
HTTP to HTTPS option.
SonicWall SuperMassive 9200/9400/9600 Getting Started Guide
49