Safety Instructions; Installation Requirements - SonicWALL SuperMassive 9200 Getting Started Manual

Safety Instructions
• Installation Requirements on page 62
• Lithium Battery Warning on page 64
• Cable Connections on page 64
Installation Requirements
WARNING:
The following conditions are required for proper installation:
• The SonicWall appliance is designed to be mounted in a
standard 19‐inch rack mount cabinet.
• Use the mounting hardware recommended by the rack
manufacturer and ensure that the rack is adequate for the
application.
• Ensure that no water or excessive moisture can enter the
unit.
• Allow unrestricted airflow around the unit and through the
vents on the side of the unit. A minimum of 1 inch
(25.44mm) clearance is recommended.
62 SonicWall SuperMassive 9200/9400/9600 Getting Started Guide
• Route cables away from power lines, fluorescent lighting
fixtures, and sources of noise such as radios, transmitters,
and broadband amplifiers.
• This product is not intended to be installed and used in a
home or public area accessible to the general population.
When installed in schools, this equipment must be installed
in a secure location accessible only by trained personnel.
• The following statement applies only to rack‐installed
products that are GS‐Marked: This equipment is not
intended for use at workplaces with visual display units, in
accordance with §2 of the German ordinance for
workplaces with visual display units.
• Mount in a location away from direct sunlight and sources
of heat. A maximum ambient temperature of 104º F (40º C)
is recommended.
• If installed in a closed or multi‐rack assembly, the operating
ambient temperature of the rack environment may be
greater than the room ambient. Therefore, consideration
should be given to installing the equipment in an
environment compatible with the maximum recommended
ambient temperature.
• Mount the SonicWall appliances evenly in the rack in order
to prevent a hazardous condition caused by uneven
mechanical loading.