Mounting The Deflector - Stihl FSA 90 R Instruction Manual

English
Mounting the Loop Handle without
Barrier Bar
7
7
8
8
4
3
5
6
1
1
Place the clamp (3) in the loop
N
handle (4) and position them both
against the shaft (5).
Position the clamp (6) against the
N
shaft.
Line up the holes.
N
Fit washers (8) on the screws (7)
N
and insert the screws in the holes.
Fit the square nuts (1) and screw
them down as far as stop.
Go to "Adjusting and Securing the
N
Loop Handle".
12
Adjusting and Securing the Loop Handle
A
4
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Distance A when using mowing heads:
Max. 30 cm (12 in)
Distance A when using metal cutting
attachments: Max. 25 cm (10 in)
Slide the handle to the required
N
position.
Line up the loop handle (4).
N
Tighten down the screws until the
N
loop handle can no longer be
rotated on the shaft. If no barrier bar
is fitted – lock the nuts if necessary.

Mounting the Deflector

Use the Right Deflector
WARNING
Deflector (1) is approved for mowing
heads only and must therefore be
mounted before fitting a mowing head
2
WARNING
Deflector (2) is approved for grass
cutting blades only and must therefore
be mounted before fitting a grass cutting
blade.
Mounting the Deflector
Deflectors (1 and 2) are both mounted to
the motor housing in the same way.
1
FSA 90 R