Mounting The Loop Handle - Stihl FSA 90 R Instruction Manual

6 Grass cutting blade 260-2
(260 mm dia.)
7 Grass cutting blade 230-4
(230 mm dia.)
8 Grass cutting blade 230-8
(230 mm dia.)
WARNING
Non-metal grass cutting blades are not
approved.
Deflectors
9 Deflector with line limiting blade
10 Deflector without line limiting blade
Handles
11 Loop handle
12 Loop handle with
13 barrier bar
Harness
14 Shoulder strap may be used
15 Full harness may be used
16 Harness for Type AR battery may
be used together with
17 padding (special accessory)
See chapter on "Fitting the Harness".
FSA 90 R

Mounting the Loop Handle

Using the Barrier Bar
A barrier bar may have to be mounted to
suit the cutting attachment you intend to
use – see "Approved Combinations of
Cutting Attachment, Deflector, Handle
and Harness".
The barrier bar comes standard with the
machine or is available as a special
accessory.
Mounting Loop Handle with Barrier Bar
2
1
Fit the square nuts (1) in the barrier
N
bar (2); the holes must line up.
4
5
6
Place the clamp (3) in the loop
N
handle (4) and position them both
against the shaft (5).
Position the clamp (6) against the
N
shaft.
Place the barrier bar (2) in position
N
as shown.
Line up the holes.
N
Insert the screws (7) in the holes
N
and screw them into the barrier
bar (2) as far as stop.
Go to "Adjusting and Securing the
N
1
Loop Handle".
English
2
3
7
11